This motor can replace corresponding model:
Danfoss OMM12 151G0001
Data and measurements may differ between makes. Check our data sheet to ensure that the motor is suitable for the use where it is built in.
MM motors are small, lightweight, and very good for small drives. A high-power density is a strong feature on MM motors. The integrated drum fuel in the drive shaft results in maximum performance in the smallest possible design.
- Hydraulic orbit motor with rear ports 3/8" BSP
- Three bolts mounting (6 mm)
- Shaft Ø16 - Standard straight shaft with keyway
- Minimum speed: 20 RPM
DISTRIBUTOR VALVE
MM series engines have coil valve: the distributor valve is integrated with the output shaft. The cardan shaft rotates the distributor valve and transmits mechanical energy from the gerotor set to the output shaft. The valve has hydrodynamic bearings and has an infinite service life when load ratings are not exceeded.
GEAR WHEEL SET
Gerotor sets have ordinary teeth. This type of motors are suitable for long operating periods at moderate pressure or short operating periods at high pressure.
