MR 160 - Hydraulic motor

MR 160 - Hydraulic motor

Product no.: MR160
2.437 NOK (excl. VAT)

Shaft Ø25 - Standard straight shaft with keyway - SAE-A 2 bolt flange

 Needle bearing, High pressure shaft seal and Painted.  

Stock: In stock ( 34 Pcs )
Pcs
Specifications
Max pressure (Bar): 200
Max flow (L/min.) 75
Størrelse (CC) 157
Torque (Nm) 430

This motor can replace corresponding model:

Danfoss OMR 160 151-0714

Data and measurements may differ between makes. Check our data sheet to ensure that the motor is suitable for the use where it is built-in.

APPLICATION

  • Conveyors
  • Metal working machines
  • Road building machines
  • Mining machinery
  • Food industries
  • Agricultural machines
  • Special vehicles etc

 

DISTRIBUTOR VALVE

MR series motors have disk valve: the distributor valve has been separated from output shaft and is driven by short cardan shaft. A balance plate counterbalances the hydraulic forces around the distributor valve. It gives the motors high efficiency- even at high pressures, and good starting characteristics.

 

GEAR WHEELSET

There are two forms of gear wheel set: Gerotor set has plain teeth and Gerolor set with teeth fitted with rollers. MR series motors have Geroler set. The rollers reduce local stress and the tangential reaction forces on the rotor reducing friction to a minimum. This gives long operating life and better efficiency even at continuous high pressures.

- Uses low pressure at start-up, provides smooth and reliable operation and high efficiency.

- The output shaft adapts in conical roller bearings, allowing high axial and radial forces. The case can offer high pressure and high torque capability in the width of applications.

- Advanced design in disk distribution flow, provides smooth and reliable operation.

- MR-motor is suitable for high loads and pressure drops.